can anything be done about the mortars?

[fabianfred]

They only come in pairs and trying to place in a hollow they interfere with each other. Can they be made to have just single ones for a spot contour?

Also the tanks and desant troopers for the T34/85 is nice....can similar be made for other tanks too? Did German troops also ride on tanks?

I love the video for the desert war

[lockie]

They only come in pairs and trying to place in a hollow they interfere with each other.

But soviet mortars already fixed in NTA1.7 and u may place them without problems, same as a german ones.

Also the tanks and desant troopers for the T34/85 is nice....can similar be made for other tanks too?

Any vehicle could be equipped with desant, it's a matter of time and desire.

I love the video for the desert war

I think I should `ve been separated video on four parts.

[fabianfred]

Sorry... I'm using NTA 1.7 on top of 2.o ... and still only have pairs of mortars....

[lockie]

and still only have pairs of mortars....

That's it. Be sure that mortars has a flag 0x5.

sov_min_01, rkka_mtbat_med, sov_pos_min_0, -1, 2, dummy, 1, 1, 0.8, 0.7, 1.0, 0x5, , 0.0;
where:
0x1+0x4=0x5
0x1 - remove contour after fill up
0x4 - unit in the trench

[frinik]

in the Common Units folder under Groups you have:


rkka_mtbat_med1,0,1,rkka_mt82,2,,,,,,,,;
rkka_mtbat_hi1,0,1,rkka_mt120,2,,,,,,,,;

The 2 at the end presumably represents the number of mortar units correct?

Thus if you reduce the number from 2 to 1 you should have only 1 mortar each of 82 and 120 mm type in the Mission Editor am I correct?

[Kyth]

You could setup 2 single-point contours to deploy them.