|
Title: setting artillery plan Post by: hardwarebob on January 22, 2012, 11:46:21 AM In section 5.4.1 of the manual, it mentions that you can set a starting and ending point for an artillery plan.
I can set a single spot by right clicking on the spot, but I can't figure out how to set a start and end point. Title: Re: setting artillery plan Post by: Rod on March 13, 2012, 04:22:35 AM I was stumped but I will be trying this. Passage from top of pg 66. from strategy and tactics pdf manual that is for the ACHTUNG: Panzer games and Blaze of Armor
you can download (link below). "To set firing line, do the following: select a commander/spotter and press [G]. Then set firing line (right click); draw a line to make it longer.) Number inside the line shows fire accuracy: 0 for minimum, 100 for maximum. Accuracy depends on how far the spotter is and on the firing line visibility. Accuracy will increase if the spotter sees the firing line and is not under fire himself. Press [`] to check the firing line visibility." http://www.graviteam.com/Manuals/tactics_manual_eng.pdf |