|
Title: Questions about formation Post by: xandu on November 13, 2013, 02:23:06 PM I did not understand the topic 2.4.2 (Formation) of the manual. How to direct the line (echelon) shown in Table 2.1. The basic principles of "ledge" movement?
* Page 46 of the manual Would like to know because I have difficulty in directing the formation angle. Title: Re: Questions about formation Post by: lavish on November 13, 2013, 02:39:49 PM While issuing order (right-click) keep holding the right mouse button down and drag a line that points to the direction, where the formation should face/ledge.
When you're done, remember to release the right mouse button. ;D Title: Re: Questions about formation Post by: xandu on November 13, 2013, 03:32:26 PM I understand the procedure, however the line itself does not assume the angle. Eg: when I determine that a 90 ° line to take a position with an angle of 45 °, the line itself does not assume the desired angle, the units that compose the line will just point individually to the desired angle at the end of the movement, instead of taking the formation to the desired angle.
Title: Re: Questions about formation Post by: lavish on November 14, 2013, 11:01:25 AM You're correct. It doesn't work anymore like that. If I recall correctly, it did work in the past.
Title: Re: Questions about formation Post by: xandu on November 14, 2013, 12:12:17 PM Do you know which version this feature stopped working?
|